Blacksmithing Welded Firepot for Forging & Blacksmith Coal Forge - 10" X 12"

Description

Blacksmith’s Coal Firepot
Welded blacksmithing coal firepot is use to forge the hammers, punches, tongs and other metal working operations. With the help of hand crank blower you can perform your desired operation mentioned here.
Fabricated Firepot is one of the important tool in a blacksmith's workshop. When fabricated firepot is exposed to temperature changes, it does not create any cracking like cast iron. It is best replacement to your cast iron firepot, fixing up an old forge or building up a new forge with the help of Hand Crank Blower.
Normally clinker breaker has a flat side up. The clinker breaker pivots on a 1/2 inch rod that has a turned down end to serve as a handle. The handle is on the outside of the forge so it can be reached. Bolt holding clinker breaker to 1/2" rod handle is on the third flat side of the breaker.
Material: MS ½-inch thick plate
Inside Dimensions: 10” x 12” x 5”
Fits in rectangular hole: Minimum 10.5” x 12.25” - Maximum 11.75” x 13.75”
Clinker Breaker: ½-inch thick plate and round handle.
Weighted Ash Dump: 11” long and 3.5” square cross-section
Air-inlet Pipe: 3” round (outside diameter) and is 4.5” long
Total Weight: 44 lbs. (Approx.)
Find our more products at simond_ca:
https://www.ebay.com/str/simondstorecalifornia
If you have any query related to product, request you to message us on ebay.com, it will be our privilege to provide you solution at the earliest & serve you better.
We kindly request you to give us the 100% positive feedback as you will be completely satisfied with the product.
SAFETY INSTRUCTIONS: WEAR SAFETY MASK | WEAR SAFETY GLASSES | WEAR SAFETY GLOVES
Image displayed is for illustrative purpose only. Actual product may vary the displayed image but features and specification would be same or higher as defined above.